Page 1 of 1

How can I reset everything?

Posted: Sun May 21, 2023 2:39 pm
by Giampy
Come posso resettare tutto?

Re: How can I reset everything?

Posted: Sun May 21, 2023 6:29 pm
by Gabe
If by 'everything' you're referring to Windows, you can reinstall the system. You can get the system and see an installation instruction video here. The drivers are also available in that topic.

If you're referring to the BIOS, you can try a BIOS discharge. The process can be seen in the following video...




Edit:

You an also boot into the BIOS by repeatedly pressing the Del key at startup, then reset the BIOS there. First, save the BIOS as the way it currently is by selecting "Save as User Defaults". This way, you can go back to the way it was if anything ever changes. Second, select "Restore Defaults", which will restore the default BIOS settings. Third and last, select 'Save Changes and Exit", after which the unit will boot into Windows.

20230521_143733.jpg
20230521_143733.jpg (301.38 KiB) Viewed 3065 times

Re: How can I reset everything?

Posted: Mon May 22, 2023 9:09 am
by barry777
Disassemble the inside of the Mini PC, there is a reset button behind the headset interface.

Re: How can I reset everything?

Posted: Mon May 22, 2023 8:28 pm
by Gabe
barry777 wrote: Mon May 22, 2023 9:09 am Disassemble the inside of the Mini PC, there is a reset button behind the headset interface.
Oops, that's right. I had forgotten about that.

--------------------------------------------------

Giampy,

If you see this before you've tried the BIOS discharge, press the button inside the headset jack instead of the method shown in the video. The button is a new thing, so I had forgotten about it being there. It does the same thing. You actually don't even have to take the unit apart. First unplug EVERYTHING from the unit, including the power. Then take a straightened paper clip, insert it into hole for the headset, and press the button inside. You'll feel it depress. After holding the button in for at least ten seconds, release it and remove the paper clip. Then reconnect everything and try starting the unit like normal.